Suzuki diagnostic system ver.8.301/25/2024 ![]() ![]() Power goes into a T near to the centre of the cluster.ģ. Make sure your network backbone is set up right, MUST have a terminating resistor on each end T piece, and devices including gauges, displays and the interface must only be connected to the leg of T pieces, never to the top. ![]() The fact that your tacho stopped working suggests you may have connected to the wrong plug).Ģ. (The SDS plug is held in a small rubber holder when not being used so make sure you have connected to the correct plug. connect an SDS adapter cable to the SDS plug (the diagnostic plug) on the engine, and plug the Suzuki interface cable into the other end of that cable, then plug the network end of the interface cable into a network T piece on your backbone. Ok to be clear, if you want BOTH the analogue tacho AND the digital data, you need to:ġ. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |